Industrial Steel Push Plate – 3" Flat Bar, Solid Steel Door Plate, Commercial Entry Hardware

Push Plate made from solid steel.

A clean, architectural plate designed for high-use doors without the stamped or decorative look. Built from solid steel flat bar, this is meant to read as permanent hardware — not an afterthought.

At a Glance:

Plate Width: 3"
Material: Solid hot-rolled steel (3/16" thick)
Mounting: 4-hole pattern, black Phillips screws included
Use Case: Interior / exterior / commercial doors

What makes this different:
No stamping
No hollow construction
No cast decorative elements
No thin sheet metal

Just solid steel, cut and finished to hold up to daily use.

The weight and surface of hot-rolled steel gives this a completely different feel from typical push plates — it reads as structural hardware, not a light-duty accessory.

Design Notes:

This plate is sized to pair cleanly with modern door pulls and bar handles. It can be matched to handle length for a consistent, architectural layout across the door.

Works equally well in residential, loft, and commercial settings where durability and simplicity matter.

Custom:

Custom sizes and layouts are available — feel free to reach out if you’re matching an existing handle or working within a specific door layout.